2022年5月5日，立夏，这个节气的到来意味着炎炎夏日的来临。又到了空调拯救我们的日子了，同时，工厂也迎来了处理机械高温频发问题的季节。为帮助各位老板解决风机设备的高温问题，我们建议各位老板在采购风机时优先选购水冷风机!下面是瑞柘水冷风机厂家小编分享的一些关于水冷风机的知识!
一、水冷罗茨风机的冷却水是自动循环吗，要不间断地加水吗?
答：是这样的，水冷罗茨风机的水是自动循环的，可以采用软化自来水，也有的采用水泵循环水，在循环过程中因为高温作用，水量也会有所损失，所以有必要时要补水，补水也可提高冷却效率。
二、罗茨风机循环水系统如果堵塞了，怎么解决?
答：我们建议水冷罗茨风机循环水建议用软水，如果条件不允许也可以使用自来水，水质必须保持干净，如果水质过硬应该先过滤及软化。在使用过程中，如果罗茨风机冷却水出现变小，可能是冷却水管路中有部分发生了阻塞，有可能被水垢或者锈蚀堵塞了，建议用醋酸(或者柠檬酸)浸泡一下，然后用高压水冲开即可。
三、水冷罗茨风机启动前要做什么准备?
答：跟风冷罗茨风机启动时要做如下相同的准备，比如，检查电压范围、仪表和电机良好;螺栓、联轴器的紧固等;齿轮箱和轴承均已经按规定添加好润滑油;转动皮带轮确认机器正常;皮带的张力正常;除了以上几点，还需要特别注意，水冷罗茨风机在启动前需检查水循环系统，是否缺水或者堵塞，如果缺水，及时补充，如果有堵塞，请及时清理通开，在风机开机之前先运行水泵，让冷却水循环起来。
四、水冷罗茨鼓风机的换季时怎么维护?
答： 特别要注意的是，水冷罗茨风机需要额外做好换季的维护，在高温和寒冷时，要做好水循环系统的保养和切换工作。在冬季，如果是间歇性地使用风机，在风机停止工作后，应当做好冷却水的排空，将水管内的水排空，避免滞留的水因低温结冰、涨裂水管，导致风机损坏;如果此时温度已经很低，风冷已经可以做到有效降温，无需额外使用水冷降温，也可以把冷却水排空，切换到风冷状态，无需每次重复运行前添加和工作后排空的工作;对于24小时连续运转的风机则无需放空冷却水。当夏季来临，环境温度再次高，风机工作时温升特别快，此时要给风机通入循环水，切换到水冷方式，有效地降低整机温度，提升输送效率。
总之，风机使用水冷的方式降温就需要根据季节的变化为风机做好保养，将风机的水冷系统做好维护。在夏季，当环境温度较高时，罗茨风机在运行时的温度较高，夏季温度高，这时就需要循环冷却水，通过水冷进行散热，这样能够一定程度上降低风机的温度，提高风机的工作效率，还能够延长风机使用时间。 在冬季的话，温度较低，如果不运转的话，需要将冷却水排出，避免结冰，冻坏风机。
友情提醒：以上风机知识是小编整理的关于我厂生产销售的水冷罗茨风机的相关知识，由于每个厂家在生产风机设备时选用的材质与铸造方法不同，所以以上知识不能保证对其他品牌有效哦!
When summer comes, what kind of blower can solve the problem of high temperatureOn May 5, 2022, the beginning of summer, the arrival of this solar term means the arrival of hot summer. It's time for air conditioning to save us. At the same time, the factory also ushered in the season of dealing with frequent mechanical high temperature problems. In order to help bosses solve the high temperature problem of fan equipment, we suggest that bosses give priority to water-cooled fans when purchasing fans! The following is a small series of Ruizhe water-cooled fan manufacturers to share some knowledge about water-cooled fans!
1、 Does the cooling water of the water-cooled roots blower circulate automatically and add water continuously?
A: Yes, the water of the water-cooled Roots fan circulates automatically. Softened tap water can be used, and some use water pump to circulate water. In the process of circulation, due to the high temperature, the amount of water will also be lost. Therefore, it is necessary to replenish water when necessary, which can also improve the cooling efficiency.
2、 If the circulating water system of Roots blower is blocked, how to solve it?
A: we suggest that the circulating water of water-cooled roots blower should be soft water. If conditions do not permit, tap water can also be used. The water quality must be kept clean. If the water quality is too hard, it should be filtered and softened first. During use, if the cooling water of Roots blower becomes smaller, some of the cooling water pipeline may be blocked, which may be blocked by scale or rust. It is recommended to soak it with acetic acid (or citric acid) and then flush it with high-pressure water.
水冷风机
3、 What preparations should be made before starting the water-cooled roots blower?
Answer: the following same preparations should be made when starting the roots blower with follow-up cooling, for example, check the voltage range, instrument and motor are in good condition; Fastening of bolts and couplings; Lubricating oil has been added to the gearbox and bearing as required; Rotate the pulley to confirm that the machine is normal; The tension of the belt is normal; In addition to the above points, special attention should be paid to check the water circulation system before starting the water-cooled Roots fan to see if it is short of water or blocked. If it is short of water, supplement it in time. If it is blocked, clean it up and open it in time. Run the water pump before starting the fan to circulate the cooling water.
4、 How to maintain the water-cooled roots blower during the season change?
A: it should be noted that the water-cooled Roots fan needs additional maintenance during the season. In case of high temperature and cold, the water circulation system should be maintained and switched. In winter, if the fan is used intermittently, after the fan stops working, the cooling water shall be drained and the water in the water pipe shall be drained to avoid the damage of the fan due to the freezing and cracking of the water pipe due to low temperature; If the temperature is very low at this time, the air cooling can effectively cool down without additional water cooling.
The cooling water can also be drained and switched to the air cooling state, without adding before operation and emptying after operation every time; For fans that operate continuously for 24 hours, there is no need to vent the cooling water. When summer comes, the ambient temperature is high again, and the temperature rises very fast when the fan works. At this time, it is necessary to feed the fan with circulating water and switch to water cooling mode to effectively reduce the temperature of the whole machine and improve the transmission efficiency.
In short, if the fan is cooled by water cooling, it is necessary to maintain the fan and the water cooling system of the fan according to the changes of seasons. In summer, when the ambient temperature is high, the operating temperature of Roots fan is high, and the temperature in summer is high. At this time, circulating cooling water is needed to dissipate heat through water cooling, which can reduce the temperature of the fan to a certain extent, improve the working efficiency of the fan, and prolong the service time of the fan. In winter, the temperature is low. If it does not operate, the cooling water needs to be discharged to avoid freezing and damaging the fan.
Friendly reminder: the above fan knowledge is the relevant knowledge about the water-cooled roots fans produced and sold by our factory. Because each manufacturer selects different materials and casting methods when producing fan equipment, the above knowledge cannot be guaranteed to be effective for other brands!
,
